1997 Acura 3.2 TL Service Manual

The 1997 Acura 3.2 TL Service Manual provides comprehensive technical information for the maintenance, repair, and service of the 1997 Acura 3.2 TL luxury sedan. This manual covers the 3.2L V6 engine, automatic transmission, electrical systems, suspension, brakes, steering, climate control, and body components. Below are key sections for specifications, maintenance schedules, troubleshooting, and repair procedures.

1. Vehicle Specifications 2. Maintenance Schedule 3. Engine System 4. Transmission 5. Electrical System 6. Suspension & Steering 7. Brake System 8. Climate Control 9. Body & Interior 10. Troubleshooting 11. Technical Service Bulletins

Vehicle Specifications

Key technical specifications for the 1997 Acura 3.2 TL.

Specification	Description
Engine Type	3.2L SOHC V6
Horsepower	225 hp @ 5600 rpm
Torque	216 lb-ft @ 4700 rpm
Transmission	4-Speed Automatic
Fuel System	Multi-Point Fuel Injection
Fuel Capacity	17.2 gallons
Curb Weight	3,505 lbs
Wheelbase	111.9 inches
Brakes	4-Wheel Disc with ABS
Suspension	4-Wheel Independent

Maintenance Schedule

Recommended maintenance intervals for optimal performance.

Oil Change: Every 7,500 miles or 12 months
Air Filter: Every 30,000 miles
Spark Plugs: Every 105,000 miles
Timing Belt: Every 105,000 miles
Transmission Fluid: Every 30,000 miles
Coolant: Every 60,000 miles
Brake Fluid: Every 3 years

WARNING! Use only Acura-approved fluids and parts. Follow torque specifications precisely.

Engine System

3.2L V6 engine service and repair procedures.

Engine Removal: Disconnect battery, drain fluids, remove accessories
Cylinder Head: Valve adjustment procedure and specifications
Fuel System: Fuel pump replacement, injector service
Ignition System: Spark plug replacement, coil testing
Cooling System: Radiator replacement, thermostat service

CAUTION! Always relieve fuel pressure before servicing fuel system components.

Transmission

Type: 4-Speed Automatic with SportShift
Fluid Capacity: 7.2 quarts
Fluid Type: Honda/Acura ATF
Service Points: Fluid change, filter replacement, shift solenoid testing
Trouble Codes: OBD-II transmission codes and diagnostics

Electrical System

Wiring diagrams, component locations, and diagnostic procedures.

Battery: 12V 60Ah, located in trunk. Alternator: 100A output. Starter: 1.4kW reduction type.

Fuse Boxes: Under-hood main fuse box, interior fuse panel. Wiring: Color-coded diagrams for all circuits. Sensors: MAP, TPS, CKP, CMP specifications and testing. Lighting: Headlight adjustment, bulb replacement procedures.

Suspension & Steering

Front and rear suspension components and power steering system.

Front Suspension: Double wishbone, strut replacement
Rear Suspension: Multi-link, alignment specifications
Steering: Power rack-and-pinion, pump service
Wheel Alignment: Camber, caster, toe specifications

Tip: Always check wheel alignment after suspension repairs.

Brake System

4-wheel disc brakes with ABS and traction control.

Brake Pads: Front and rear pad replacement procedures
Rotors: Minimum thickness specifications and resurfacing
ABS: Wheel speed sensor testing and replacement
Bleeding: Proper brake fluid bleeding procedure
Parking Brake: Cable adjustment and service

WARNING! Always use new brake fluid from sealed containers.

Climate Control

Automatic climate control system service and repair.

AC System: R134a refrigerant, compressor replacement. Heater: Core replacement, blend door operation. Controls: Automatic temperature control diagnostics.

Body & Interior

Body panel replacement, interior trim, and electrical accessories.

CAUTION! Use proper trim removal tools to avoid damage to interior components.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Engine won't start	Battery, starter, fuel pump	Check battery voltage, test starter, verify fuel pressure
Transmission slips	Low fluid, worn clutch packs	Check fluid level and condition, pressure test
ABS light on	Wheel sensor, hydraulic unit	Scan for codes, test wheel sensors
Overheating	Thermostat, radiator, water pump	Check coolant level, test thermostat, inspect water pump
Electrical issues	Alternator, battery, grounds	Test charging system, check ground connections

Reset: Clear codes with OBD-II scanner after repairs.

Service: Contact Acura dealer for technical support and genuine parts.