The 1998 Acura CL Service Manual provides comprehensive technical information for maintenance, repair, and servicing of the 1998 Acura CL model. This manual covers engine systems, transmission, chassis, electrical systems, diagnostics, troubleshooting procedures, specifications, and maintenance schedules for both 2.2L and 3.0L engine variants. Below are key sections covering service procedures, specifications, maintenance, and technical data.
Vehicle identification, model variations, service precautions, and general specifications.
| Item | Specification |
|---|---|
| Model Years | 1997-1999 Acura CL |
| Engine Options | 2.2L F22B2 I4, 3.0L J30A1 V6 |
| Transmission | 4-speed automatic, 5-speed manual |
| Fuel System | Multi-point fuel injection |
| Brake System | Front disc/rear drum with ABS |
| Electrical System | 12-volt negative ground |
| Cooling System | Pressurized with radiator |
| Oil Capacity | 4.5 quarts (with filter) |
| Coolant Capacity | 6.9 quarts |
| Fuel Capacity | 17.2 gallons |
Complete engine service procedures including removal, installation, and component repair.
WARNING! Timing belt must be replaced at recommended intervals to prevent engine damage.
Fuel injection system, ignition system, emission controls, and diagnostic procedures.
CAUTION! Always relieve fuel pressure before servicing fuel system components.
Wiring diagrams, component locations, and electrical system troubleshooting.
Systems Covered: Starting system, charging system, lighting, instruments, power accessories, audio system, security system.
Battery: Testing and replacement. Alternator: Output test and replacement. Starter: Testing and removal. Fuses and relays: Location and testing. Wiring harness: Repair procedures and connector service.
Front and rear suspension service, alignment procedures, power steering system.
Tip: Always check alignment after suspension component replacement.
Hydraulic brake system service, ABS diagnosis, and component replacement.
WARNING! Always use specified brake fluid and follow proper bleeding procedures.
Climate control system service, AC component replacement, and heater core service.
Body panel replacement, glass service, interior trim, and accessory installation.
Factory recommended maintenance intervals and service procedures.
| Service Interval | Required Maintenance |
|---|---|
| 7,500 miles | Oil change, tire rotation, inspection |
| 15,000 miles | Oil change, air filter, cabin filter |
| 30,000 miles | Transmission fluid, coolant, brake fluid |
| 60,000 miles | Timing belt, spark plugs, drive belts |
| 90,000 miles | Major service including all fluids |
| Symptom | Possible Cause | Corrective Action |
|---|---|---|
| Engine won't start | Battery, starter, fuel pump | Check battery voltage, fuel pressure, spark |
| Poor acceleration | Fuel filter, air filter, sensors | Replace filters, test MAF and O2 sensors |
| Transmission slipping | Low fluid, worn clutches | Check fluid level and condition |
| Brake vibration | Warped rotors, worn pads | Inspect and replace brake components |
| Electrical issues | Alternator, battery, grounds | Test charging system, check grounds |
Diagnostic Tools: OBD-II scanner required for engine codes.
Technical Support: Acura dealer service department for complex issues.