1999 Acura TL Service Manual PDF

The 1999 Acura TL Service Manual provides comprehensive technical information for maintenance, repair, and service procedures for the 1999 Acura TL model. This manual covers engine systems, transmission, suspension, brakes, electrical systems, heating and air conditioning, body components, and general maintenance specifications. Below are key sections for technical specifications, maintenance procedures, troubleshooting, and service guidelines.

1. Vehicle Specifications 2. Maintenance Schedules 3. Engine Systems 4. Transmission & Drivetrain 5. Suspension & Steering 6. Brake Systems 7. Electrical Systems 8. Heating & A/C 9. Body & Interior 10. Troubleshooting Guide 11. Technical Service Bulletins

Vehicle Specifications

Key technical specifications for the 1999 Acura TL including engine, transmission, dimensions, and capacities.

SpecificationDescription
Engine Type3.2L SOHC V6 VTEC
Displacement3,215 cc
Horsepower225 hp @ 5,300 rpm
Torque216 lb-ft @ 4,700 rpm
Transmission4-speed automatic
Fuel SystemProgrammed Fuel Injection (PGM-FI)
Fuel Capacity17.2 gallons
Curb Weight3,505 lbs
Wheelbase108.1 inches
Overall Length193.2 inches

Maintenance Schedules

Recommended maintenance intervals and service procedures for optimal vehicle performance.

  1. Oil and filter change: Every 7,500 miles or 12 months
  2. Air filter replacement: Every 30,000 miles
  3. Spark plug replacement: Every 105,000 miles
  4. Timing belt replacement: Every 105,000 miles
  5. Transmission fluid change: Every 30,000 miles
  6. Brake fluid replacement: Every 3 years
  7. Coolant replacement: Every 5 years or 60,000 miles

WARNING! Always use genuine Acura parts and fluids for optimal performance and warranty compliance.

Engine Systems

Detailed service procedures for engine components and systems.

Transmission & Drivetrain

Service procedures for automatic transmission and drivetrain components.

Automatic Transmission: Fluid service, shift cable adjustment, valve body service, torque converter replacement.

Drivetrain: Drive axle removal and installation, CV joint service, differential service procedures.

Transmission fluid capacity: 2.9 quarts (drain and refill), 7.4 quarts (total capacity). Use only Honda/Acura ATF.

Suspension & Steering

Service procedures for front and rear suspension systems and power steering.

  1. Front strut replacement and alignment procedures
  2. Rear suspension component service and alignment
  3. Power steering pump and rack service
  4. Wheel bearing replacement procedures
  5. Stabilizer bar and bushing replacement

Tip: Always perform wheel alignment after suspension component replacement.

Brake Systems

Complete brake system service including disc brakes, ABS, and parking brake.

  1. Front brake pad and rotor replacement procedure
  2. Rear brake service and adjustment
  3. ABS component service and troubleshooting
  4. Brake fluid bleeding procedure
  5. Parking brake adjustment and cable replacement
  6. Master cylinder and booster service

WARNING! Always test brake system operation before road use. Use only DOT 3 or DOT 4 brake fluid.

Electrical Systems

Wiring diagrams, component locations, and service procedures for all electrical systems.

SystemService Procedures
Starting SystemStarter removal, testing, and installation
Charging SystemAlternator testing and replacement
Lighting SystemHeadlight adjustment, bulb replacement
Instrument PanelGauge cluster service and bulb replacement
Power AccessoriesWindow motors, door locks, mirror controls
Audio SystemRadio removal and speaker replacement

Heating & A/C

Climate control system service including heater core, A/C compressor, and refrigerant procedures.

Heater core replacement procedure, blower motor service, A/C compressor R-134a service, evaporator and condenser service, control panel diagnosis.

CAUTION! A/C system service requires proper certification and equipment. Never open refrigerant lines without proper recovery equipment.

Body & Interior

Body panel alignment, interior trim, and accessory service procedures.

Troubleshooting Guide

SymptomPossible CauseCorrective Action
Engine won't startBattery, starter, ignition switchCheck battery voltage, test starter, inspect ignition switch
Poor accelerationFuel filter, air filter, sensorsReplace fuel and air filters, test MAF and O2 sensors
Transmission slippingLow fluid, worn clutchesCheck fluid level and condition, test line pressure
Brake vibrationWarped rotors, worn padsResurface or replace rotors, install new pads
Electrical issuesBattery, alternator, groundsTest charging system, check ground connections
A/C not coolingRefrigerant, compressor, leaksCheck refrigerant pressure, test compressor clutch

Technical Service Bulletins

Manufacturer-issued service bulletins and common issues for 1999 Acura TL.

Common TSBs include transmission shift quality improvements, power window regulator service, ignition switch replacement, and suspension noise fixes. Contact Acura dealer for specific TSB information and software updates.

Service Support: 1-800-382-2238; www.acura.com

1999 Acura TL Service Manual PDF © - All Rights Reserved 2025