2000 Acura Integra Haynes Manual PDF

The 2000 Acura Integra Haynes Manual provides comprehensive repair and maintenance information for the 1998-2001 Acura Integra models. This manual covers engine systems, transmission, brakes, suspension, electrical systems, heating and air conditioning, bodywork, and routine maintenance procedures. Below are key sections for vehicle specifications, maintenance schedules, repair procedures, troubleshooting, and technical data.

1. Vehicle Specifications 2. Maintenance Schedules 3. Engine Repair 4. Transmission Service 5. Brake Systems 6. Electrical Systems 7. Suspension & Steering 8. Heating & AC 9. Body & Interior 10. Troubleshooting 11. Wiring Diagrams

Vehicle Specifications

Technical specifications for 2000 Acura Integra models including engine, transmission, dimensions, and capacities.

Specification	Details
Engine Type	1.8L 4-cylinder DOHC VTEC
Horsepower	140 hp @ 6300 rpm
Torque	127 lb-ft @ 5200 rpm
Transmission	5-speed manual / 4-speed automatic
Fuel Capacity	13.2 gallons
Curb Weight	2570-2670 lbs
Wheelbase	101.2 inches
Overall Length	172.4 inches
Brake System	Front disc / rear drum
Fuel System	Multi-point fuel injection

Maintenance Schedules

Recommended maintenance intervals and service procedures for optimal vehicle performance.

Oil and filter change: Every 7,500 miles or 12 months
Air filter replacement: Every 30,000 miles
Spark plugs: Replace every 60,000 miles
Timing belt: Replace every 90,000 miles
Brake fluid: Replace every 30,000 miles
Coolant flush: Every 60,000 miles or 5 years

IMPORTANT! Follow manufacturer recommendations for severe driving conditions.

Engine Repair

Comprehensive engine service procedures including removal, installation, and component replacement.

Engine removal: Disconnect battery, drain fluids, remove accessories
Cylinder head service: Valve adjustment, head gasket replacement
Timing belt replacement: Align timing marks, tension properly
Oil pump service: Remove and inspect for wear
Cooling system: Thermostat, water pump replacement

WARNING! Always disconnect battery before starting engine work.

Transmission Service

Manual Transmission: Fluid change every 30,000 miles, clutch replacement procedure
Automatic Transmission: Fluid and filter service, shift cable adjustment
Clutch System: Pedal adjustment, hydraulic system bleeding
Differential: Fluid service, seal replacement
Shift Linkage: Adjustment and bushing replacement

Brake Systems

Complete brake system service including disc brakes, drum brakes, and ABS components.

Component	Service Procedure
Front Brake Pads	Inspect wear, replace if below 1/8 inch
Rear Brake Shoes	Adjust and replace worn components
Brake Rotors	Resurface or replace if worn
Brake Fluid	Bleed system, check for leaks
ABS System	Diagnose codes, sensor replacement

Electrical Systems

Electrical system diagnosis and repair including battery, alternator, starter, and lighting.

Battery testing: Load test, check connections
Alternator output: Test voltage and current
Starter circuit: Check solenoid and wiring
Lighting systems: Headlight adjustment, bulb replacement
Fuse panel: Location and circuit identification

CAUTION! Disconnect battery before electrical work to prevent shorts.

Suspension & Steering

Front and rear suspension service including struts, control arms, and steering components.

Front strut replacement: Remove wheel, support control arm
Ball joint inspection: Check for play and wear
Tie rod ends: Replace worn components, align steering
Rear suspension: Shock absorber replacement
Wheel alignment: Specifications and adjustment procedures

Heating & AC

HVAC system service including compressor, condenser, and heater core replacement.

AC System: Evacuation and recharge procedures
Compressor: Removal and installation
Heater Core: Dash removal procedure
Blower Motor: Testing and replacement
Control Panel: Diagnosis and repair

Body & Interior

Body panel replacement, interior trim, and glass service procedures.

Component	Service Procedure
Door Panel	Removal for window regulator service
Bumper Cover	Removal and installation
Seat Removal	Disconnect electrical connectors
Dashboard	Removal for heater core access
Window Regulator	Motor and mechanism replacement

Troubleshooting

Common problems and solutions for 2000 Acura Integra models.

Symptom	Possible Cause	Corrective Action
Engine won't start	Battery, starter, fuel pump	Check battery voltage, test starter, listen for fuel pump
Overheating	Thermostat, water pump, radiator	Check coolant level, test thermostat, inspect water pump
Brake vibration	Warped rotors, worn pads	Resurface or replace rotors, inspect brake pads
Electrical issues	Alternator, battery, grounds	Test charging system, check battery connections
Transmission problems	Fluid level, clutch, linkage	Check fluid, adjust clutch, inspect shift linkage

Wiring Diagrams

Complete electrical wiring diagrams for all vehicle systems including color codes and connector locations.

Engine control system wiring
Lighting circuit diagrams
Instrument cluster wiring
Power window and lock circuits
AC and heating system wiring
ABS brake system diagrams

NOTE: Use multimeter for circuit testing and follow safety procedures.