The 2000 Acura TL Service Manual provides comprehensive technical information for maintenance, repair, and service procedures for the 2000 Acura TL model. This manual covers engine systems, transmission, suspension, brakes, electrical systems, heating and air conditioning, body components, and general maintenance schedules. Below are key sections for technical specifications, maintenance procedures, troubleshooting, and service guidelines.
Technical specifications for the 2000 Acura TL including engine, transmission, dimensions, and capacities.
| Specification | Description |
|---|---|
| Engine Type | 3.2L V6 SOHC 24-valve |
| Displacement | 3,215 cc |
| Horsepower | 225 hp @ 5,600 rpm |
| Torque | 216 lb-ft @ 4,700 rpm |
| Transmission | 4-speed automatic |
| Fuel System | Programmed Fuel Injection (PGM-FI) |
| Fuel Capacity | 17.2 gallons |
| Curb Weight | 3,505 lbs |
| Wheelbase | 108.1 inches |
| Brake System | 4-wheel disc brakes with ABS |
Recommended maintenance intervals and service procedures for optimal vehicle performance.
WARNING! Always use genuine Acura parts and fluids for optimal performance and warranty compliance.
Detailed service procedures for engine components and systems.
Automatic transmission service, maintenance, and repair procedures.
CAUTION! Use only Honda ATF-Z1 automatic transmission fluid.
Complete brake system service including ABS diagnostics and repair.
| Component | Service Procedure |
|---|---|
| Brake Pads | Inspection and replacement procedure |
| Brake Rotors | Measurement and machining specifications |
| Brake Calipers | Rebuilding and replacement |
| ABS System | Diagnostic trouble codes and sensor testing |
| Brake Lines | Inspection and replacement procedures |
| Master Cylinder | Bench bleeding and installation |
Front and rear suspension components and power steering system service.
Tip: Always check alignment after suspension component replacement.
Complete electrical system diagnostics and repair procedures.
Climate control system service and repair procedures.
WARNING! A/C system service requires proper certification and equipment.
Body components, interior trim, and accessory service procedures.
| Component | Service Procedure |
|---|---|
| Door Panels | Removal and installation |
| Dashboard | Disassembly and component access |
| Seats | Removal and power seat motor service |
| Windows | Regulator and motor replacement |
| Exterior Trim | Bumper and molding replacement |
| Glass | Windshield and window replacement |
Common problems and diagnostic procedures for the 2000 Acura TL.
| Symptom | Possible Cause | Corrective Action |
|---|---|---|
| Engine won't start | Battery, starter, fuel pump | Check battery voltage, test starter, verify fuel pressure |
| Rough idle | Vacuum leaks, dirty injectors | Inspect vacuum lines, clean fuel injectors |
| Transmission slipping | Low fluid, worn clutches | Check fluid level, perform pressure test |
| ABS light on | Wheel sensors, module | Scan for codes, test wheel speed sensors |
| A/C not cooling | Low refrigerant, compressor | Check refrigerant pressure, test compressor clutch |
| Electrical issues | Ground connections, fuses | Inspect grounds, check all fuses and relays |
General service procedures and technical data for professional technicians.
Service Support: Contact Acura technical support for additional assistance.