The 2007 Acura RDX Repair Manual provides comprehensive technical information for servicing and maintaining the 2007 Acura RDX luxury compact SUV. This manual covers the 2.3L turbocharged i-VTEC engine, 5-speed automatic transmission with Sequential SportShift, Super Handling All-Wheel Drive (SH-AWD) system, electrical systems, suspension, brakes, heating and air conditioning, body components, and troubleshooting procedures. Below are key sections for maintenance, repair procedures, specifications, and diagnostic information.
Vehicle identification, model variations, service precautions, and general specifications.
| Component | Specification |
|---|---|
| Model Year | 2007 |
| Engine | 2.3L K23A1 turbocharged i-VTEC |
| Horsepower | 240 hp @ 6000 rpm |
| Torque | 260 lb-ft @ 4500 rpm |
| Transmission | 5-speed automatic with SportShift |
| Drivetrain | Super Handling All-Wheel Drive (SH-AWD) |
| Fuel System | Programmed Fuel Injection (PGM-FI) |
| Brakes | 4-wheel disc with ABS |
| Curb Weight | Approx. 3,900 lbs |
| Fuel Capacity | 17.2 gallons |
Complete engine service procedures including removal, installation, and component replacement.
WARNING! Allow engine to cool completely before servicing. Use proper lifting equipment for engine removal.
Diagnostic procedures for engine performance issues and fuel system maintenance.
CAUTION! Always relieve fuel pressure before servicing fuel system components.
Front MacPherson strut and rear multi-link suspension service procedures.
Front Suspension: Strut replacement, control arm service, stabilizer bar links. Rear Suspension: Multi-link component replacement, alignment procedures. Steering: Power steering pump service, rack and pinion inspection, tie rod replacement.
Suspension Specifications: Front camber -0°20' ± 45', Front caster +3°10' ± 45', Front toe 0 ± 2mm, Rear camber -1°00' ± 45', Rear toe +2 ± 2mm.
Hydraulic brake system and ABS component service procedures.
Tip: Always use new brake fluid from sealed containers to prevent moisture contamination.
Complete electrical system wiring diagrams and component testing procedures.
WARNING! Disconnect battery negative terminal before performing electrical work to prevent short circuits.
Climate control system service and refrigerant handling procedures.
Air Conditioning: R-134a refrigerant capacity 1.21-1.34 lbs, Compressor oil PAG 46, System pressure testing. Heating: Heater core replacement, blower motor service, temperature blend door actuator diagnosis.
Body panel replacement, interior trim service, and glass installation procedures.
CAUTION! Use proper trim removal tools to avoid damaging interior components.
Recommended service intervals and maintenance procedures.
| Service Interval | Required Maintenance |
|---|---|
| 7,500 miles | Oil and filter change, tire rotation |
| 15,000 miles | Engine air filter inspection, brake inspection |
| 30,000 miles | Transmission fluid inspection, coolant replacement |
| 60,000 miles | Spark plug replacement, drive belt inspection |
| 105,000 miles | Timing chain inspection, coolant hose replacement |
| Symptom | Possible Cause | Corrective Action |
|---|---|---|
| Engine misfire | Faulty spark plugs, coil packs | Check ignition components, replace as needed |
| Transmission slipping | Low fluid, worn clutch packs | Check fluid level, perform pressure test |
| ABS warning light | Wheel speed sensor failure | Scan for codes, test sensor circuits |
| A/C not cooling | Low refrigerant, compressor failure | Perform leak test, check compressor clutch |
| Electrical drain | Parasitic draw, alternator issues | Perform parasitic draw test, check charging system |
Reset Procedures: Maintenance minder reset, throttle position sensor relearn, power window initialization.
Technical Support: Acura Technical Information System, authorized dealer service departments