2007 Acura TL Type S Service Manual

The 2007 Acura TL Type S is a premium sports sedan featuring a 3.5L V6 VTEC engine producing 286 horsepower, 5-speed automatic transmission with Sequential SportShift, sport-tuned suspension, Brembo front brakes, and luxury amenities. This service manual covers maintenance procedures, technical specifications, troubleshooting, and repair instructions for optimal vehicle performance and longevity.

1. Vehicle Specifications 2. Maintenance Schedule 3. Engine System 4. Transmission 5. Brake System 6. Suspension & Steering 7. Electrical System 8. Heating & AC 9. Body & Interior 10. Troubleshooting

Vehicle Specifications

Technical specifications for the 2007 Acura TL Type S model.

Specification	Details
Engine	3.5L V6 VTEC
Horsepower	286 hp @ 6200 rpm
Torque	256 lb-ft @ 5000 rpm
Transmission	5-speed automatic with Sequential SportShift
Drivetrain	Front-wheel drive
Brakes Front	Brembo 4-piston calipers, 13.0" rotors
Brakes Rear	11.8" rotors
Suspension	Sport-tuned double-wishbone front, multi-link rear
Wheels	18" alloy wheels
Fuel Capacity	17.1 gallons

Maintenance Schedule

Recommended maintenance intervals for optimal vehicle performance.

Oil and filter change: Every 7,500 miles or 12 months
Tire rotation: Every 7,500 miles
Air filter replacement: Every 30,000 miles
Brake fluid replacement: Every 3 years
Transmission fluid: Every 30,000 miles
Coolant replacement: Every 60,000 miles or 5 years
Spark plugs: Every 105,000 miles

WARNING! Always use genuine Acura parts and fluids for optimal performance and warranty compliance.

Engine System

Service procedures for the 3.5L V6 VTEC engine.

Oil Change: Use 5W-20 premium synthetic oil, capacity 4.5 quarts
Spark Plugs: NGK IZFR6K11S, gap 0.039-0.043 inches
Timing Belt: Replace every 105,000 miles
Cooling System: Use Honda Type 2 coolant, capacity 7.4 quarts
Fuel System: Fuel pressure: 50-60 psi
Compression: Standard: 185 psi, minimum: 135 psi

CAUTION! Engine components operate at high temperatures; allow cooling before servicing.

Transmission

5-speed automatic transmission with Sequential SportShift service procedures.

Fluid change: Use ATF-Z1, capacity 2.9 quarts during change
Fluid level check: Engine running, transmission in Park
Shift cable adjustment: Ensure proper gear selection
Transmission control module: Diagnostic procedures
SportShift operation: Manual shifting functionality

Tip: Check transmission fluid regularly for proper color and level.

Brake System

Brembo front brake system maintenance and service.

Component	Specification
Front Brake Pads	Minimum thickness: 0.12 inches
Front Rotors	Minimum thickness: 1.18 inches
Rear Brake Pads	Minimum thickness: 0.12 inches
Rear Rotors	Minimum thickness: 0.39 inches
Brake Fluid	DOT 3 or DOT 4

WARNING! Always replace brake components in axle sets for balanced braking performance.

Suspension & Steering

Sport-tuned suspension and power steering system service.

Front Suspension: Double-wishbone with stabilizer bar
Rear Suspension: Multi-link with stabilizer bar
Alignment Specs: Front camber: -0°30' ± 45', toe: 0°00' ± 0°12'
Power Steering: Fluid type: Honda Power Steering Fluid
Struts/Shocks: Inspect for leaks and wear
Wheel Bearings: Check for play and noise

Electrical System

Electrical components and system diagnostics.

Battery: 12V, 70Ah, located in trunk
Alternator: Output 130A
Starter: 1.4 kW
Fuse boxes: Under-hood and driver's side interior
Lighting: Headlight aiming and bulb replacement
Audio/Navigation: System diagnostics and reset procedures

CAUTION! Disconnect battery before performing electrical work to prevent shorts.

Heating & AC

Climate control system service and maintenance.

Refrigerant: R-134a, capacity 1.54 lbs
Compressor Oil: PAG 46, 5.1 oz
AC Pressure: High side: 190-220 psi, Low side: 28-35 psi
Heater Core: Flush procedure
Blower Motor: Replacement instructions

Body & Interior

Body components and interior feature maintenance.

Door panel removal for window regulator service
Seat removal and track adjustment
Dashboard component access procedures
Exterior trim and molding replacement
Paint and body repair specifications

Troubleshooting

Common issues and diagnostic procedures.

Symptom	Possible Cause	Corrective Action
Engine misfire	Spark plugs, coils, fuel injectors	Check ignition components; scan for codes
Transmission slipping	Low fluid, worn clutches	Check fluid level and condition; pressure test
Brake vibration	Warped rotors	Resurface or replace rotors; check calipers
Electrical issues	Battery, alternator, grounds	Load test battery; check charging system
AC not cooling	Low refrigerant, compressor	Check pressures; leak test system

Reset Procedures: Maintenance minder, TPMS, and navigation system resets.

Service Support: Contact Acura dealership or certified technician for complex repairs.