2008 Acura RDX Repair Manual

The 2008 Acura RDX Repair Manual provides comprehensive technical information for servicing and maintaining the Acura RDX luxury compact SUV. This manual covers the 2.3L turbocharged K23A1 engine, 5-speed automatic transmission with Sequential SportShift, Super Handling All-Wheel Drive (SH-AWD) system, electrical systems, suspension, brakes, and all major components. Below are key sections for maintenance procedures, specifications, troubleshooting, and repair instructions.

1. Vehicle Specifications 2. Engine Systems 3. Transmission & Drivetrain 4. Electrical Systems 5. Suspension & Steering 6. Brake Systems 7. Heating & AC 8. Body & Interior 9. Maintenance Schedules 10. Diagnostic Procedures 11. Troubleshooting Guide

Vehicle Specifications

Key technical data for the 2008 Acura RDX with 2.3L turbocharged engine and SH-AWD system.

SpecificationDescription
Engine Type2.3L DOHC i-VTEC turbocharged inline-4
Horsepower240 hp @ 6000 rpm
Torque260 lb-ft @ 4500 rpm
Transmission5-speed automatic with SportShift
DrivetrainSuper Handling All-Wheel Drive (SH-AWD)
Fuel SystemProgrammed Fuel Injection (PGM-FI)
Brake System4-wheel disc with ABS and EBD
SuspensionFront MacPherson strut, rear multi-link
Fuel Capacity17.8 gallons
Curb Weight3,924 lbs

Engine Systems

Service procedures for the K23A1 turbocharged engine and related components.

  1. Engine removal and installation procedures
  2. Turbocharger system service and maintenance
  3. Timing chain replacement and adjustment
  4. Cylinder head and valve train service
  5. Cooling system maintenance and repair
  6. Fuel system diagnostics and repair

WARNING! Allow engine to cool completely before performing any service work. Follow all safety procedures.

Transmission & Drivetrain

Service information for the 5-speed automatic transmission and SH-AWD system.

  1. Transmission fluid service and replacement
  2. SH-AWD system diagnostics and repair
  3. Transfer case service procedures
  4. Drive shaft and axle maintenance
  5. Transmission control module programming
  6. Shift solenoid testing and replacement

CAUTION! Use only Honda ATF-Z1 transmission fluid. Incorrect fluid may damage transmission.

Electrical Systems

Suspension & Steering

Front MacPherson strut and rear multi-link suspension service procedures.

Front Suspension: Strut replacement, control arm service, stabilizer bar, ball joints. Rear Suspension: Multi-link components, trailing arms, stabilizer bar. Steering: Power steering pump, rack and pinion, tie rods. Wheel Alignment: Specifications and adjustment procedures.

Brake Systems

4-wheel disc brakes with ABS, EBD, and brake assist systems.

  1. Brake pad and rotor replacement procedures
  2. ABS module diagnostics and service
  3. Brake fluid bleeding and system maintenance
  4. Parking brake adjustment and repair
  5. Brake booster testing and replacement

Tip: Always use DOT 3 or DOT 4 brake fluid. Replace fluid every 3 years or 45,000 miles.

Heating & AC

Climate control system service and repair procedures.

  1. AC compressor replacement and service
  2. Refrigerant recovery and recharge procedures
  3. Heater core replacement
  4. Blower motor and resistor service
  5. Climate control module diagnostics
  6. AC pressure switch testing
  7. Condenser and evaporator service
  8. Temperature blend door actuator replacement

WARNING! AC system contains high pressure refrigerant. Use proper recovery equipment and safety gear.

Body & Interior

Body panel, trim, and interior component service procedures.

Maintenance Schedules

Recommended service intervals and procedures for optimal vehicle performance.

Oil Change: Every 7,500 miles or 12 months. Transmission Fluid: Every 30,000 miles. Coolant: Replace every 60,000 miles or 5 years. Spark Plugs: Replace every 105,000 miles. Timing Chain: Inspect every 100,000 miles.

Diagnostic Procedures

Using Honda Diagnostic System (HDS) and troubleshooting techniques.

Troubleshooting Guide

SymptomPossible CauseCorrective Action
Engine misfireSpark plugs, coils, fuel injectorsCheck ignition system; test fuel pressure; scan for codes.
Transmission slippingLow fluid, worn clutchesCheck fluid level and condition; perform pressure test.
SH-AWD warning lightSystem fault, sensor failureScan for DTCs; check rear differential fluid; test sensors.
Brake pulsationWarped rotorsMeasure rotor runout; replace or resurface rotors.
AC not coolingLow refrigerant, compressor failureCheck refrigerant pressure; test compressor clutch; check fuses.

Reset Procedures: Maintenance minder, oil life, TPMS system reset.

Technical Support: Acura dealer service department or certified technician.

2008 Acura RDX Repair Manual © - All Rights Reserved 2025