2008 Acura TL Service Manual PDF

The 2008 Acura TL Service Manual provides comprehensive technical information for maintaining, diagnosing, and repairing the 2008 Acura TL luxury sports sedan. This manual covers the 3.2L and 3.5L V6 engines, 5-speed automatic transmission, suspension systems, electrical systems, body components, and all mechanical systems. Below are key sections for maintenance procedures, technical specifications, troubleshooting guides, and repair instructions.

1. General Information 2. Maintenance Schedule 3. Engine Mechanical 4. Engine Performance 5. Transmission 6. Suspension & Steering 7. Brakes 8. Electrical Systems 9. Body & Interior 10. Heating & AC 11. Troubleshooting

General Information

Vehicle identification, model variations, safety precautions, and service procedures overview.

ComponentSpecification
Model Years2008 Acura TL
Engine Options3.2L J32A3 V6, 3.5L J35A8 V6
Transmission5-speed automatic with Sequential SportShift
Drive SystemFront-wheel drive
Fuel SystemProgrammed Fuel Injection (PGM-FI)
Brake System4-wheel disc with ABS
Suspension4-wheel independent
Electrical12-volt system
Oil Capacity4.5 quarts (with filter)
Coolant Capacity7.4 quarts

Maintenance Schedule

Recommended service intervals and maintenance procedures.

  1. Oil and filter change: Every 7,500 miles or 12 months
  2. Tire rotation: Every 7,500 miles
  3. Air filter replacement: Every 30,000 miles
  4. Spark plugs: Every 105,000 miles
  5. Timing belt: Every 105,000 miles (3.2L engine)
  6. Transmission fluid: Every 30,000 miles
  7. Brake fluid: Every 3 years
  8. Coolant: Every 10 years or 120,000 miles

WARNING! Always use genuine Acura parts and fluids for optimal performance and warranty compliance.

Engine Mechanical

Engine components, specifications, and repair procedures.

Engine Performance

Fuel system, ignition system, and engine management.

Fuel System: PGM-FI with sequential multi-port fuel injection. Ignition System: Direct ignition system with individual coil packs. Emission Controls: Three-way catalytic converter, heated oxygen sensors, EVAP system. Engine Control Module: PCM controls fuel, ignition, and emission systems.

Diagnostic procedures for engine performance issues including misfire diagnosis, fuel system testing, and sensor replacement.

Transmission

5-speed automatic transmission with SportShift manual mode.

  1. Fluid type: Honda/Acura ATF-Z1 or equivalent
  2. Fluid capacity: 2.9 quarts (drain and refill)
  3. Shift solenoid testing and replacement
  4. Transmission control module programming
  5. Shift cable adjustment procedure

Tip: Regular transmission fluid changes prevent premature wear and shifting issues.

Suspension & Steering

Front and rear suspension systems, steering components.

  1. Front suspension: Double wishbone with coil springs
  2. Rear suspension: Multi-link with coil springs
  3. Steering type: Power-assisted rack-and-pinion
  4. Wheel alignment specifications and procedures
  5. Strut and shock absorber replacement
  6. Control arm and bushing replacement
  7. Stabilizer bar and link replacement

WARNING! Always perform wheel alignment after suspension component replacement.

Brakes

Brake system components, specifications, and service procedures.

ComponentSpecification
Front BrakesVentilated discs, 11.8 inch
Rear BrakesSolid discs, 11.1 inch
ABS System4-channel with EBD
Brake FluidDOT 3 or DOT 4
Pad ReplacementFront: 0.39 inch minimum
Rotor MinimumFront: 1.02 inch, Rear: 0.39 inch

Electrical Systems

Battery, charging system, starting system, and electrical components.

Body & Interior

Body components, interior trim, and accessory systems.

Exterior body panel replacement, door adjustment, glass replacement, seat removal and installation, dashboard components, center console, and trim pieces. Power window motor replacement, door lock actuator service, sunroof mechanism repair.

Heating & AC

Climate control system components and service procedures.

  1. AC refrigerant type: R-134a
  2. Refrigerant capacity: 17.6 - 19.4 oz
  3. Compressor oil: ND-OIL 8
  4. Heater core replacement procedure
  5. AC compressor replacement
  6. Blower motor and resistor replacement
  7. Climate control module diagnosis

CAUTION! AC system service requires proper certification and equipment.

Troubleshooting

SymptomPossible CauseCorrective Action
Engine won't startBattery, starter, fuel systemCheck battery voltage, fuel pressure, spark
Rough idleVacuum leak, dirty throttle bodyInspect vacuum lines, clean throttle body
Transmission slippingLow fluid, worn clutchesCheck fluid level and condition
Brake vibrationWarped rotorsResurface or replace brake rotors
Electrical issuesBad ground, blown fuseCheck grounds and fuses
AC not coolingLow refrigerant, compressorCheck refrigerant pressure and compressor

Diagnostic Tools: Honda/Acura diagnostic system (HDS) recommended for advanced diagnostics.

Technical Support: Contact Acura dealer service department for technical assistance.

2008 Acura TL Service Manual PDF © - All Rights Reserved 2025