2008 Acura TL Type S Service Manual

The 2008 Acura TL Type S is a high-performance luxury sedan featuring a 3.5L V6 engine producing 286 horsepower, 5-speed automatic transmission with Sequential SportShift, sport-tuned suspension, Brembo brakes, and premium audio system. This service manual covers maintenance procedures, technical specifications, troubleshooting, and repair guidelines for qualified technicians.

Vehicle Specifications

Complete technical specifications for the 2008 Acura TL Type S.

Maintenance Schedule

Recommended service intervals and maintenance procedures.

1. Oil Change: Every 7,500 miles or 12 months
2. Tire Rotation: Every 7,500 miles
3. Air Filter: Replace every 30,000 miles
4. Transmission Fluid: Replace every 60,000 miles
5. Brake Fluid: Replace every 3 years
6. Spark Plugs: Replace every 105,000 miles
7. Timing Belt: Replace every 105,000 miles

WARNING! Use only Acura-approved fluids and parts. Follow torque specifications precisely.

Engine System

J35A8 engine service procedures and specifications.

1. Engine Removal: Disconnect battery, drain fluids, remove accessories
2. Valve Adjustment: Cold engine procedure, 0.20-0.24mm intake, 0.25-0.29mm exhaust
3. Timing Belt: Align marks, proper tension procedure
4. Oil System: Capacity 4.5 quarts with filter
5. Cooling System: Capacity 7.4 quarts, bleed procedure required

CAUTION! Engine must be cold before performing valve adjustment.

Transmission

• Type: 5-speed automatic with SportShift
• Fluid Capacity: 3.1 quarts (drain and refill)
• Fluid Type: ATF-Z1 or equivalent
• Shift Points: Programmed for sport driving characteristics
• Diagnostic Codes: Access via OBD-II port
• Service: Fluid changes every 60,000 miles
• Filter: Internal transmission filter

Brake System

Brembo brake system service and maintenance procedures.

Front Brakes: Brembo 4-piston calipers, 13.0" rotors. Rear Brakes: Single piston calipers, 12.6" rotors.

Pad Replacement: Remove caliper, compress piston, install new pads. Rotor Service: Minimum thickness 30.5mm front, 9.0mm rear. Brake Bleeding: Sequence RR, LR, RF, LF. Fluid Specification: DOT 3 or DOT 4.

Suspension & Steering

Sport-tuned suspension components and steering system.

1. Front Strut Replacement: Support engine, remove lower ball joint
2. Rear Shock Replacement: Access through trunk, remove upper mount
3. Alignment Specifications: Camber -0°30' ± 45', Caster +3°15' ± 45'
4. Power Steering: Electric power steering, no fluid service required

Tip: Always replace suspension components in pairs.

Electrical System

Wiring diagrams, component locations, and electrical troubleshooting.

1. Battery: 12V 70Ah, located in trunk
2. Alternator: 130 amp output
3. Starter: 1.4 kW reduction type
4. Fuse Boxes: Under-hood and driver's side kick panel
5. Lighting: HID headlights with auto-leveling
6. Audio: Premium 10-speaker system with subwoofer

WARNING! Disconnect battery before performing electrical work.

Heating & AC

Climate control system service and refrigerant procedures.

Refrigerant: R-134a, Capacity 1.38-1.59 lbs. Compressor: Variable displacement. Heater Core: Dash removal required. AC Service: Evacuate and recharge procedure.

Body & Interior

Body panel replacement, interior trim, and accessory installation.

Body Dimensions: Wheelbase 108.3", Length 190.1", Width 72.2". Interior Features: Leather seats, power moonroof, auto-dimming mirror.

Diagnostic Procedures

OBD-II diagnostic trouble codes and troubleshooting procedures.

Technical Service Bulletins

Common issues and factory-recommended solutions.

• TSB 07-001: Transmission shudder - software update required
• TSB 08-045: Front brake noise - revised pad compound available
• TSB 09-012: Navigation system freezing - software update
• TSB 10-028: Power steering warning light - sensor replacement
• TSB 11-015: AC compressor noise - revised compressor available

Service: Contact Acura dealer for TSB application and parts availability.