The 2010 Acura TL Service Manual provides comprehensive technical information for maintenance, repair, and service procedures for the 2010 Acura TL model. This manual covers engine systems, transmission, suspension, brakes, electrical systems, body components, and diagnostic procedures. Below are key sections for specifications, maintenance schedules, troubleshooting, repair procedures, and technical data.
Technical specifications for the 2010 Acura TL including engine, dimensions, capacities, and performance data.
| Specification | Description |
|---|---|
| Engine Type | 3.5L V6 SOHC VTEC |
| Horsepower | 280 hp @ 6200 rpm |
| Torque | 254 lb-ft @ 5000 rpm |
| Transmission | 5-speed automatic with Sequential SportShift |
| Fuel Capacity | 18.5 gallons |
| Curb Weight | 3715 lbs |
| Wheelbase | 109.3 inches |
| Overall Length | 195.7 inches |
| Brake System | 4-wheel disc with ABS |
| Fuel Economy | 18 city / 26 highway mpg |
Recommended maintenance intervals and service procedures for optimal vehicle performance.
WARNING! Always use genuine Acura parts and fluids for optimal performance and warranty compliance.
Detailed service procedures for engine components and systems.
Service procedures for automatic transmission and drivetrain components.
Transmission Service: Fluid change procedure, filter replacement, shift solenoid testing. Driveshaft: Removal and installation. Differential: Fluid service and seal replacement.
Transmission fluid specifications: ATF-Z1 or equivalent. Differential fluid: Hypoid gear oil SAE 80W-90.
Maintenance and repair procedures for suspension and steering systems.
Tip: Always check wheel alignment after suspension component replacement.
Complete brake system service including disc brakes, ABS, and parking brake.
WARNING! Always test brake system operation before road use. Use only DOT 3 or DOT 4 brake fluid.
Diagnostic and repair procedures for electrical components and wiring.
Battery: Testing, replacement, and maintenance. Alternator: Output testing and replacement. Starter: Removal and installation. Lighting: Headlight, taillight, and interior light replacement. Fuses: Location and amperage specifications.
Wiring diagrams: Color-coded schematics for all electrical systems.
Service procedures for body panels, trim, and interior components.
Door panel removal, seat service, dashboard components, window regulator replacement, mirror adjustment, and trim installation procedures.
Step-by-step diagnostic procedures for common issues and warning lights.
OBD-II code retrieval, scan tool usage, system testing procedures, and component verification methods for accurate diagnosis.
Important safety information for technicians and DIY enthusiasts.
CAUTION! Always disconnect battery before electrical work. Use proper lifting equipment. Wear safety glasses. Follow all environmental regulations for fluid disposal.
| Symptom | Possible Cause | Corrective Action |
|---|---|---|
| Engine won't start | Battery, starter, fuel system | Check battery voltage, test starter, verify fuel pressure |
| Transmission slipping | Low fluid, worn clutches | Check fluid level and condition, perform pressure test |
| Brake vibration | Warped rotors | Measure rotor thickness, replace if below specification |
| Electrical issues | Blown fuses, bad grounds | Check fuse box, inspect ground connections |
| Overheating | Coolant leak, thermostat | Pressure test system, check thermostat operation |
Technical Support: Contact Acura dealer service department for complex issues
Parts Information: Use genuine Acura parts for optimal performance and warranty