2014 Acura RDX Service Manual

The 2014 Acura RDX Service Manual provides comprehensive technical information for maintenance, repair, and service procedures for the 2014 Acura RDX luxury crossover SUV. This manual covers the 3.5L V6 engine, 6-speed automatic transmission, all-wheel drive system, electrical systems, suspension, brakes, and other critical components. Below are key sections for maintenance schedules, technical specifications, troubleshooting, and repair procedures.

1. Maintenance Schedule 2. Engine Specifications 3. Transmission Service 4. Brake System 5. Suspension & Steering 6. Electrical System 7. Cooling System 8. Fuel System 9. Diagnostic Procedures 10. Safety Precautions 11. Troubleshooting Guide

Maintenance Schedule

Recommended service intervals for optimal vehicle performance and longevity.

Service IntervalRequired Maintenance
7,500 milesOil and filter change, tire rotation
15,000 milesEngine air filter replacement, brake inspection
30,000 milesTransmission fluid change, cabin air filter
45,000 milesSpark plug replacement, coolant flush
60,000 milesBrake fluid replacement, drive belt inspection
90,000 milesTiming belt replacement, transfer case fluid

Engine Specifications

Technical details for the 3.5L V6 engine.

Transmission Service

6-speed automatic transmission maintenance procedures.

  1. Fluid change: Drain and refill with ATF DW-1 fluid
  2. Filter replacement: Replace transmission filter every 60,000 miles
  3. Fluid level check: With engine at operating temperature
  4. Shift solenoid testing: Use diagnostic tool for error codes

WARNING! Use only specified ATF fluid; improper fluid can damage transmission.

Brake System

Front and rear brake system service procedures.

ComponentSpecification
Front Brake PadsMinimum thickness: 3mm
Rear Brake PadsMinimum thickness: 2mm
Rotor ThicknessFront: 28mm min, Rear: 18mm min
Brake FluidDOT 3 or DOT 4
Fluid ReplacementEvery 3 years or 45,000 miles

Suspension & Steering

Front MacPherson strut and rear multi-link suspension maintenance.

  1. Strut inspection: Check for leaks and wear every 15,000 miles
  2. Ball joint inspection: Check for play during tire rotation
  3. Alignment specifications: Front camber: -0°20' ± 45', Toe: 0°00' ± 0°12'
  4. Power steering fluid: Use Honda Power Steering Fluid

Electrical System

Battery, charging, and electrical component specifications.

Cooling System

Radiator, thermostat, and coolant service procedures.

  1. Coolant type: Honda Long Life Antifreeze/Coolant
  2. Coolant mixture: 50/50 with distilled water
  3. Thermostat opening: 180°F (82°C)
  4. Radiator cap pressure: 1.1 bar (16 psi)
  5. Coolant replacement: Every 60,000 miles or 5 years

Fuel System

Fuel pump, injectors, and fuel delivery system.

Diagnostic Procedures

Using diagnostic tools and interpreting trouble codes.

  1. Connect Honda Diagnostic System (HDS) to DLC
  2. Retrieve trouble codes from PCM
  3. Follow diagnostic flow charts for specific codes
  4. Clear codes after repair completion
  5. Perform system readiness tests

Safety Precautions

Essential safety procedures for all service work.

WARNING! Always disconnect battery before electrical work. Use jack stands when lifting vehicle. Wear safety glasses and gloves. Avoid contact with hot engine components. Properly dispose of fluids and batteries.

Troubleshooting Guide

SymptomPossible CauseCorrective Action
Engine won't startDead battery, faulty starterCheck battery voltage; test starter circuit
Poor fuel economyDirty air filter, oxygen sensorReplace air filter; check O2 sensor readings
Brake vibrationWarped rotorsResurface or replace brake rotors
Transmission slippingLow fluid, worn clutch packsCheck fluid level; perform pressure test
OverheatingLow coolant, thermostat stuckCheck coolant level; test thermostat operation

Technical Support: Contact Acura Technical Service at 1-800-382-2238

Parts Information: Genuine Acura parts required for warranty coverage

2014 Acura RDX Service Manual © - All Rights Reserved 2025