2015 Acura TLX Service Manual

The 2015 Acura TLX Service Manual provides comprehensive technical information for maintenance, repair, and service procedures for the Acura TLX model year 2015. This manual covers engine systems (2.4L and 3.5L V6), transmission (8-speed DCT and 9-speed automatic), chassis, electrical systems, body, and accessories. Below are key sections for maintenance schedules, technical specifications, troubleshooting, and repair procedures.

1. Maintenance Schedule 2. Engine Systems 3. Transmission Service 4. Brake Systems 5. Electrical Systems 6. Suspension & Steering 7. HVAC System 8. Body & Interior 9. Technical Specifications 10. Diagnostic Trouble Codes 11. Troubleshooting Guide

Maintenance Schedule

Recommended service intervals for optimal performance and longevity.

Service Interval	Required Maintenance
7,500 miles/12 months	Oil and filter change, tire rotation, fluid inspection
15,000 miles/12 months	Replace engine air filter, inspect brake system
30,000 miles/24 months	Replace cabin air filter, inspect drive belts
60,000 miles/48 months	Replace spark plugs, transmission fluid service
105,000 miles/84 months	Replace timing belt (3.5L V6), coolant replacement

Engine Systems

Service procedures for 2.4L inline-4 and 3.5L V6 engines.

Oil change procedure: Drain plug torque 30 ft-lbs, filter torque 22 ft-lbs
Spark plug replacement: Gap 0.039-0.043 inches, torque 13 ft-lbs
Timing belt replacement (3.5L V6): Align marks, tensioner adjustment
Cooling system: Burp procedure, thermostat replacement
Fuel system: Fuel filter service, injector cleaning

WARNING! Always disconnect battery before servicing electrical components. Allow engine to cool before opening cooling system.

Transmission Service

Service procedures for 8-speed DCT and 9-speed automatic transmissions.

Fluid change: Use Honda ATF DW-1, capacity 3.1 quarts
Filter replacement: Internal/external filter service intervals
Adaptation reset: Required after fluid service
Shift solenoid testing: Resistance specifications and testing

CAUTION! Use only specified transmission fluid. Incorrect fluid can cause transmission damage.

Brake Systems

Brake Pad Replacement: Front pad thickness minimum 3mm, rear 2mm
Rotor Specifications: Minimum thickness front 28.4mm, rear 10.0mm
Brake Fluid: DOT 3 or DOT 4, replace every 3 years
ABS System: Bleeding procedure requires scan tool
Parking Brake: Cable adjustment and service

Electrical Systems

Battery, charging, starting systems and wiring diagrams.

Battery: 12V 60Ah, replacement procedure, terminal torque 70 in-lbs

Alternator: Output 150A, testing procedures, replacement

Starter: Draw test specifications, solenoid testing

Fuse Boxes: Under-hood and interior fuse locations and ratings

Lighting: Headlight adjustment, bulb replacement procedures

Suspension & Steering

Front MacPherson strut and rear multi-link suspension service.

Strut replacement: Spring compressor required, alignment necessary
Control arms: Bushing inspection and replacement
Steering system: Power steering fluid type and bleeding
Wheel alignment: Specifications and adjustment procedures

Tip: Always perform wheel alignment after suspension component replacement.

HVAC System

Heating, ventilation, and air conditioning service procedures.

AC refrigerant: R-1234yf, capacity 14.1-15.9 oz
Compressor replacement: Evacuation and recharge required
Blower motor: Removal and testing procedures
Heater core: Replacement requires dashboard removal

WARNING! AC system contains high pressure. Use proper safety equipment when servicing.

Body & Interior

Body panel replacement, interior trim, and accessory installation.

Technical Specifications

Complete technical data and torque specifications.

CAUTION! Always use torque wrench for critical fasteners. Overtightening can cause component failure.

Diagnostic Trouble Codes

OBD-II codes and diagnostic procedures for common issues.

Troubleshooting Guide

Symptom	Possible Cause	Corrective Action
Engine won't start	Battery, starter, fuel pump	Check battery voltage, fuel pressure, starter operation
Transmission shifting hard	Fluid level, solenoids	Check fluid level and condition, test shift solenoids
Brake vibration	Warped rotors, tire balance	Measure rotor runout, check tire balance
AC not cooling	Refrigerant charge, compressor	Check refrigerant pressure, compressor clutch operation
Electrical issues	Battery, alternator, grounds	Load test battery and alternator, check ground connections

Reset Procedures: Maintenance minder reset, transmission adaptation

Technical Support: Acura Technical Information System (TIS)