2017 Acura RDX Service Manual

The 2017 Acura RDX Service Manual provides comprehensive technical information for maintenance, repair, and service procedures for the 2017 Acura RDX luxury crossover SUV. This manual covers the 3.5L V6 engine, 6-speed automatic transmission, all-wheel drive system, electrical systems, suspension, brakes, and all major components. Below are key sections for maintenance schedules, technical specifications, repair procedures, troubleshooting, and service guidelines.

1. Maintenance Schedule 2. Engine Specifications 3. Transmission Service 4. Brake System 5. Suspension & Steering 6. Electrical System 7. Heating & AC 8. Body & Interior 9. Diagnostic Procedures 10. Technical Data 11. Troubleshooting

Maintenance Schedule

Recommended service intervals for optimal performance and longevity.

Service Interval	Required Maintenance
7,500 miles	Oil and filter change, tire rotation, fluid inspection
15,000 miles	Air filter replacement, brake inspection, cabin air filter
30,000 miles	Transmission fluid change, spark plugs, brake fluid
45,000 miles	Coolant replacement, drive belt inspection
60,000 miles	Major service including all fluids and filters
90,000 miles	Timing belt replacement (if equipped), comprehensive inspection

Engine Specifications

3.5L V6 engine technical data and service requirements.

Engine Type: 3.5L SOHC i-VTEC V6
Displacement: 3,471 cc (211.8 cu in)
Horsepower: 279 hp @ 6,200 rpm
Torque: 252 lb-ft @ 4,900 rpm
Compression Ratio: 11.2:1
Fuel System: Direct injection
Oil Capacity: 4.5 quarts (with filter)
Spark Plug Gap: 0.039-0.043 in (1.0-1.1 mm)

Transmission Service

6-speed automatic transmission maintenance and repair procedures.

Fluid change: Drain and refill with ATF DW-1 every 30,000 miles
Filter replacement: Replace transmission filter during fluid service
Shift solenoid testing: Use diagnostic tool to check solenoid operation
Transmission control module: Reset adaptations after service

WARNING! Use only Honda/Acura ATF DW-1 fluid. Incorrect fluid may damage transmission.

Brake System

Front and rear brake system service procedures.

Component	Specification
Front Brake Pads	Minimum thickness: 0.12 in (3 mm)
Rear Brake Pads	Minimum thickness: 0.12 in (3 mm)
Brake Rotors	Minimum thickness: 0.94 in (24 mm) front, 0.43 in (11 mm) rear
Brake Fluid	DOT 3 or DOT 4, replace every 3 years
Parking Brake	Adjust when lever travel exceeds 8 clicks

Suspension & Steering

Front MacPherson strut and rear multi-link suspension service.

Strut replacement: Support vehicle properly before removal
Control arm bushing: Inspect for wear and cracking
Stabilizer links: Check for looseness and noise
Wheel alignment: Specifications: Camber -0°30' ± 45', Toe 0°00' ± 10'
Power steering: Use Honda Power Steering Fluid, check for leaks

Electrical System

Battery, charging, starting, and electronic systems.

Battery: 12V, 65Ah, CCA 550A
Alternator: 150A output
Starter: 1.4 kW reduction type
Fuses: Main fuse 150A, under-hood and interior fuse boxes
Lighting: Headlight low beam 55W, high beam 60W

CAUTION! Disconnect battery before electrical work to prevent short circuits.

Heating & AC

Climate control system service and refrigerant handling.

AC refrigerant: R-1234yf, capacity 15.9-17.6 oz (450-500g)
Compressor oil: PAG 46, 4.0 fl oz (120 ml)
Heater core: Flush if cooling system contaminated
Blower motor: Test resistor and motor operation

WARNING! R-1234yf is flammable. Use approved recovery equipment.

Body & Interior

Exterior and interior component service procedures.

Door panel removal: Remove screws and clips carefully
Headliner: Support during removal to prevent damage
Seat belt inspection: Check retraction and locking mechanism
Glass replacement: Use proper adhesive and setting procedure

Diagnostic Procedures

Using diagnostic tools and troubleshooting methods.

Connect HDS scanner to DLC under dashboard
Read and clear DTCs from all control modules
Perform system tests and active commands
Check data list for sensor readings and system status
Follow troubleshooting tree for specific symptoms

Technical Data

General specifications and capacities.

Item	Specification
Fuel Capacity	16.0 gal (60.6 L)
Curb Weight	3,781 lb (1,715 kg)
Tire Size	P235/60R18
Wheel Size	18x7.5J
Tire Pressure	32 psi (220 kPa) front and rear
Cargo Capacity	26.1 cu ft (rear seats up)

Troubleshooting

Common issues and corrective actions.

Symptom	Possible Cause	Corrective Action
Engine won't start	Battery, starter, fuel pump	Check battery voltage, listen for fuel pump, test starter
Rough idle	Spark plugs, coils, vacuum leak	Inspect plugs and coils, check for vacuum leaks
Transmission slipping	Low fluid, worn clutch packs	Check fluid level and condition, scan for codes
Brake vibration	Warped rotors, stuck calipers	Measure rotor runout, inspect caliper slides
AC not cooling	Refrigerant leak, compressor	Check refrigerant pressure, test compressor clutch

Technical Support: 1-800-382-2238; www.acura.com