The Acura 2013 TSX Repair Manual provides comprehensive technical information for maintenance, repair, and troubleshooting of the 2013 Acura TSX model. This manual covers engine systems, transmission, suspension, brakes, electrical systems, heating and air conditioning, body components, and diagnostic procedures. Below are key sections for technical specifications, maintenance schedules, repair procedures, and troubleshooting guides.
Technical specifications for the 2013 Acura TSX including engine, dimensions, capacities, and performance data.
| Specification | Details |
|---|---|
| Engine Type | 2.4L I4 DOHC i-VTEC |
| Horsepower | 201 hp @ 7000 rpm |
| Torque | 172 lb-ft @ 4400 rpm |
| Transmission | 5-speed automatic or 6-speed manual |
| Fuel Capacity | 18.5 gallons |
| Curb Weight | 3450 lbs |
| Wheelbase | 106.4 inches |
| Overall Length | 185.6 inches |
| Brake System | 4-wheel disc brakes with ABS |
| Fuel Economy | 22 city / 31 highway mpg |
Recommended maintenance intervals and service requirements.
WARNING! Always use genuine Acura parts and fluids for optimal performance and warranty compliance.
Detailed repair procedures for the 2.4L I4 engine components.
CAUTION! Always disconnect battery before performing electrical work. Use proper lifting equipment for engine removal.
Complete brake system maintenance and repair procedures.
Front Brakes: Pad replacement, rotor resurfacing, caliper service
Rear Brakes: Pad/shoe replacement, drum service, parking brake adjustment
ABS System: Wheel speed sensor replacement, hydraulic control unit service
Brake Bleeding: Proper procedure for air removal from brake lines
Front and rear suspension components and steering system repairs.
Tip: Always perform wheel alignment after suspension component replacement.
Wiring diagrams and electrical component service procedures.
WARNING! Always disconnect battery before performing electrical repairs to prevent short circuits.
Climate control system maintenance and repair.
AC System: Compressor replacement, refrigerant charging procedures
Heater Core: Removal and installation procedure
Blower Motor: Replacement and resistor service
Climate Control: Panel and actuator motor replacement
Exterior and interior component repair procedures.
Body Panels: Door, hood, and trunk lid adjustment
Glass: Windshield and window replacement
Seats: Removal and track repair
Dashboard: Component removal and installation
CAUTION! Use proper trim removal tools to avoid damaging interior components.
OBD-II diagnostic trouble codes and troubleshooting procedures.
| Code | Description | Probable Cause |
|---|---|---|
| P0300 | Random/Multiple Cylinder Misfire | Ignition coils, spark plugs, fuel injectors |
| P0420 | Catalyst System Efficiency Below Threshold | Catalytic converter, oxygen sensors |
| P0171 | System Too Lean (Bank 1) | Vacuum leaks, MAF sensor, fuel pressure |
| P0452 | Evaporative Emission Control System Pressure Sensor Low | Fuel cap, vapor canister, pressure sensor |
| U0155 | Lost Communication With Instrument Panel | Wiring, instrument cluster, CAN bus |
| Symptom | Possible Cause | Corrective Action |
|---|---|---|
| Engine won't start | Battery, starter, ignition switch | Check battery voltage, test starter, verify ignition switch operation |
| Poor acceleration | Fuel filter, air filter, throttle position sensor | Replace fuel and air filters, test TPS operation |
| Brake vibration | Warped rotors, worn pads | Resurface or replace rotors, install new brake pads |
| AC not cooling | Refrigerant leak, compressor failure | Perform leak test, check compressor clutch operation |
| Electrical issues | Battery, alternator, ground connections | Test charging system, clean battery terminals and grounds |
Reset Procedures: Maintenance reminder reset, electronic parking brake calibration
Technical Support: Acura dealership service department or certified technicians