The Acura CL Service Manual provides comprehensive technical information for maintaining and repairing the Acura CL luxury coupe. This manual covers all major systems including engine, transmission, suspension, brakes, electrical, and body components. Below are key sections for maintenance procedures, technical specifications, troubleshooting, and service intervals.
Overview of Acura CL models covered in this service manual including model years, VIN decoding, and vehicle identification.
| Model Year | Engine Options | Transmission |
|---|---|---|
| 1997-1999 | 2.2L F22B1, 3.0L J30A1 | 4-speed automatic, 5-speed manual |
| 2000-2003 | 3.2L J32A1, 3.2L J32A2 | 5-speed automatic, 6-speed manual |
| Special Features | VTEC system, ABS, Traction Control | Power steering, Climate control |
Recommended service intervals for optimal vehicle performance and longevity.
WARNING! Always use genuine Acura parts for optimal performance and warranty compliance.
Detailed procedures for engine maintenance and repair.
Automatic and manual transmission service procedures.
CAUTION! Use only recommended transmission fluids to prevent damage.
Complete brake system maintenance and repair.
| Component | Service Interval | Specifications |
|---|---|---|
| Brake Pads | Inspect every 15,000 miles | Minimum thickness: 3mm |
| Brake Rotors | Replace if below minimum thickness | Minimum thickness: 20.5mm |
| Brake Fluid | Replace every 3 years | DOT 3 or DOT 4 |
| ABS System | Diagnostic procedures | ABS module testing |
Front and rear suspension components and steering system service.
Wiring diagrams, component locations, and diagnostic procedures.
Climate control system service and repair.
AC Service: Refrigerant charging, compressor replacement, evaporator service. Heating System: Heater core replacement, blower motor service, temperature control.
Body panel replacement, interior component service, and trim procedures.
Complete technical data for all Acura CL models.
| Specification | 2.2L Model | 3.0L/3.2L Models |
|---|---|---|
| Displacement | 2.2L (2156cc) | 3.0L/3.2L (2997cc/3210cc) |
| Horsepower | 145 hp @ 5600 rpm | 225-260 hp @ 5500-6200 rpm |
| Torque | 147 lb-ft @ 4500 rpm | 210-232 lb-ft @ 3500-5000 rpm |
| Compression Ratio | 8.8:1 | 10.0:1 - 10.5:1 |
| Fuel System | Multi-point injection | Programmed fuel injection |
Common problems and solutions for Acura CL models.
| Symptom | Possible Cause | Corrective Action |
|---|---|---|
| Engine won't start | Battery, starter, fuel pump | Check battery voltage, test starter, verify fuel pressure |
| Transmission slipping | Low fluid, worn clutches | Check fluid level, perform pressure test |
| Brake vibration | Warped rotors | Resurface or replace brake rotors |
| Electrical issues | Alternator, battery, grounds | Test charging system, check ground connections |
| Overheating | Thermostat, water pump, radiator | Test cooling system, replace faulty components |
Service Support: Contact Acura customer service for technical assistance or visit authorized Acura service centers.