Acura RSX Type S Manual Remote Start

The Acura RSX Type S Manual Remote Start system allows for convenient engine starting from a distance using a remote transmitter. This aftermarket system is designed specifically for the 2002-2006 Acura RSX Type S with manual transmission, featuring safety interlocks to prevent accidental starting while in gear. Below are key sections for installation, operation, programming, troubleshooting, and safety features.

1. System Overview 2. Installation Requirements 3. Remote Start Operation 4. Remote Programming 5. Safety Features 6. System Specifications 7. LED Indicator Codes 8. Maintenance 9. Regulatory Information 10. Troubleshooting

System Overview

Key components: Remote transmitter, Control module, Antenna, Wiring harness, LED status indicator.

Component	Description
Remote transmitter	2-button remote with 500ft range
Control module	Main brain unit with safety circuits
Antenna	Receives remote signals
Wiring harness	Vehicle-specific plug-and-play connectors
LED status indicator	Shows system status and diagnostic codes
Hood pin switch	Safety switch to prevent start with open hood
Neutral safety switch	Manual transmission safety interlock
Tachometer wire	Engine RPM sensing for proper start sequence

Installation Requirements

Professional installation recommended. Ensure vehicle is properly prepared.

Vehicle preparation: Park in neutral with parking brake engaged.
Battery connection: Disconnect negative battery terminal before installation.
Module placement: Mount control module in dry, protected location.
Wiring: Connect using provided vehicle-specific harness.
Safety switches: Install hood pin switch and verify neutral safety circuit.

WARNING! Improper installation may cause vehicle damage or safety hazards. Use professional installer.

Remote Start Operation

Remote start sequence requires specific safety conditions to be met.

Pre-start check: Ensure vehicle is in neutral, parking brake engaged, hood closed.
Activation: Press LOCK button twice within 3 seconds to start engine.
Runtime: Engine runs for 15 minutes then shuts off automatically.
Extension: Press LOCK button once during runtime to extend by 15 minutes.
Shutdown: Press UNLOCK button for 2 seconds to shut off engine remotely.

CAUTION! Never attempt remote start while vehicle is in gear. Always verify neutral position.

Remote Programming

Remote Range: Up to 500 feet line of sight.
Battery Type: CR2032 3V lithium battery.
Programming Mode: Enter programming by pressing both buttons for 5 seconds until LED flashes.
Multi-remote: System supports up to 4 remotes.
Battery Life: Approximately 1 year with normal use.

Safety Features

Multiple safety interlocks prevent accidental or unsafe operation.

Manual Transmission Safety: Requires neutral position verification. Hood Safety: Prevents start with open hood. Brake Safety: Applying brake shuts off engine. Runtime Limit: Automatic shutdown after 15 minutes. Low Voltage Protection: Prevents start if battery voltage is too low.

System Specifications

Operating Voltage: 12V DC vehicle battery.
Current Draw: 15mA standby, 200mA during start.
Temperature Range: -40°F to 185°F (-40°C to 85°C).
RF Frequency: 315 MHz or 433 MHz (region dependent).
Start Attempts: 3 attempts maximum per start sequence.
Crank Time: Adjustable 0.5-3 seconds.
Runtime: Adjustable 5-30 minutes.

LED Indicator Codes

LED flashes indicate system status and diagnostic information.

LED Pattern	Meaning
1 Flash	System armed and ready
2 Flashes	Remote start in progress
3 Flashes	Engine running normally
4 Flashes	Safety interlock active
5 Flashes	Low battery voltage
Rapid Flash	System error or valet mode

Maintenance

Regular maintenance ensures reliable operation.

Remote battery: Replace CR2032 battery annually or when range decreases.
System check: Verify all safety switches function properly every 6 months.
Wiring inspection: Check for loose connections or corrosion.
Module cleaning: Keep control module area free of moisture and debris.

Tip: Test remote start monthly to ensure all systems function correctly.

Regulatory Information

FCC Part 15: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. IC: Complies with Industry Canada license-exempt RSS standard(s). For support, contact manufacturer or visit www.acuraoemparts.com.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Remote doesn't work	Dead battery/obstruction	Replace battery; ensure clear line of sight to vehicle.
Engine doesn't start	Safety interlock active	Verify neutral position, hood closed, parking brake engaged.
Starts then stalls	Tachometer signal issue	Check tach wire connection; may need professional adjustment.
Reduced range	Battery/low signal	Replace remote battery; check for RF interference.
LED flashing rapidly	System error	Enter valet mode to reset; check all connections.

Reset: Disconnect battery for 5 minutes to reset system.

Service: Contact professional installer for complex issues.