Acura RSX Type S Service Manual PDF

The Acura RSX Type S Service Manual provides comprehensive technical information for the 2002-2006 Acura RSX Type S model. This manual covers engine specifications (K20A2 2.0L i-VTEC), transmission systems (6-speed manual), suspension, brakes, electrical systems, maintenance schedules, troubleshooting procedures, and repair instructions. Below are key sections for specifications, maintenance, repair procedures, and technical data.

1. Vehicle Specifications 2. Maintenance Schedule 3. Engine System 4. Transmission & Drivetrain 5. Suspension & Steering 6. Brake System 7. Electrical System 8. Body & Interior 9. Troubleshooting Guide 10. Technical Service Bulletins

Vehicle Specifications

Detailed technical specifications for the Acura RSX Type S model years 2002-2006.

Specification	Details
Engine Type	K20A2 2.0L DOHC i-VTEC 4-cylinder
Horsepower	200 hp @ 7800 rpm
Torque	142 lb-ft @ 7000 rpm
Transmission	6-speed manual
Final Drive Ratio	4.388:1
Brake System	4-wheel disc with ABS
Suspension	Front MacPherson strut, rear double wishbone
Fuel Capacity	13.2 gallons
Curb Weight	2778 lbs
0-60 mph	6.7 seconds

Maintenance Schedule

Recommended maintenance intervals and service procedures.

Oil Change: Every 7,500 miles or 12 months
Spark Plugs: Replace every 105,000 miles
Timing Chain: Inspection every 60,000 miles
Brake Fluid: Replace every 3 years
Coolant: Replace every 10 years or 120,000 miles
Transmission Fluid: Replace every 30,000 miles

WARNING! Always use genuine Acura parts and fluids for optimal performance and warranty compliance.

Engine System

K20A2 i-VTEC engine service and repair procedures.

Valve Adjustment: Check every 105,000 miles
Timing Chain Replacement: Special tools required
VTEC System: Solenoid testing and replacement
Fuel System: Injector cleaning and replacement
Ignition System: Coil pack diagnostics
Cooling System: Radiator and thermostat replacement

CAUTION! Engine work requires proper lifting equipment and safety precautions.

Transmission & Drivetrain

Transmission Type: 6-speed manual
Gear Ratios: 1st: 3.267, 2nd: 2.130, 3rd: 1.517, 4th: 1.147, 5th: 0.921, 6th: 0.738
Clutch System: Hydraulic actuation
Differential: Helical limited-slip
Shift Linkage: Cable-operated
Transmission Fluid: Honda MTF only

Suspension & Steering

Front MacPherson strut and rear double wishbone suspension systems.

Front Suspension: Struts, lower control arms, stabilizer bar. Rear Suspension: Upper/lower control arms, toe arms, stabilizer bar. Steering: Rack and pinion with electric power steering.

Alignment Specifications: Front camber -0°30' ± 45', Front caster +3°00' ± 45', Front toe 0 ± 2mm, Rear camber -1°30' ± 45', Rear toe +2 ± 2mm.

Brake System

4-wheel disc brakes with ABS and electronic brake distribution.

Front Brakes: 11.8-inch ventilated discs
Rear Brakes: 10.2-inch solid discs
Brake Pad Replacement: Front and rear procedures
Rotor Resurfacing: Specifications and tolerances
ABS System: Diagnostic trouble codes
Brake Bleeding: Proper sequence and procedure

Tip: Always replace brake components in axle sets for optimal performance.

Electrical System

Wiring diagrams, component locations, and diagnostic procedures.

Battery: Testing and replacement
Alternator: Output testing
Starter: Removal and installation
Lighting Systems: Headlight adjustment
ECU: Diagnostic port locations
Fuse Box: Locations and amperage ratings
Wiring: Color codes and connector types

WARNING! Disconnect battery before performing electrical work to prevent shorts.

Body & Interior

Body panel replacement, interior trim, and accessory installation.

Troubleshooting Guide

Common issues and diagnostic procedures for the RSX Type S.

Symptom	Possible Cause	Corrective Action
Engine misfire	Spark plugs/coils	Check ignition system; replace plugs/coils as needed
Grinding gears	Synchros/fluid	Inspect synchronizers; change transmission fluid
Brake vibration	Warped rotors	Resurface or replace brake rotors
Electrical issues	Ground connections	Check and clean all ground connections
VTEC not engaging	Solenoid/pressure	Test VTEC solenoid; check oil pressure

Reset: ECU reset procedure: Disconnect battery for 10 minutes.

Technical Service Bulletins

Manufacturer-issued updates and common factory fixes.

TSB 05-001: Third gear synchronizer improvement. TSB 06-012: ABS module software update. TSB 07-045: Clutch master cylinder replacement. TSB 08-023: Power steering pump noise. For latest TSBs, contact Acura dealer or visit techinfo.honda.com.