Acura TSX Workshop Manual

The Acura TSX Workshop Manual provides comprehensive technical information for the maintenance, repair, and service of the Acura TSX vehicle. This manual covers all major systems including engine, transmission, suspension, brakes, electrical, and body components. Below are key sections for vehicle specifications, maintenance procedures, troubleshooting, and technical data.

1. Vehicle Specifications 2. Maintenance Schedule 3. Engine System 4. Transmission System 5. Brake System 6. Suspension & Steering 7. Electrical System 8. Body & Interior 9. Diagnostic Procedures 10. Technical Data 11. Troubleshooting Guide

Vehicle Specifications

Key technical specifications for Acura TSX models including engine options, dimensions, and performance data.

Specification	Description
Engine Type	2.4L DOHC i-VTEC 4-cylinder
Horsepower	201 hp @ 7000 rpm
Torque	172 lb-ft @ 4500 rpm
Transmission	6-speed manual or 5-speed automatic
Fuel System	Programmed Fuel Injection (PGM-FI)
Brake System	4-wheel disc brakes with ABS
Suspension	Front: Double wishbone, Rear: Multi-link
Wheelbase	105.1 inches
Length	183.3 inches
Curb Weight	Approximately 3,200 lbs

Maintenance Schedule

Recommended maintenance intervals and service procedures for optimal vehicle performance.

Oil and filter change: Every 7,500 miles or 12 months
Tire rotation: Every 7,500 miles
Brake fluid replacement: Every 3 years
Spark plug replacement: Every 105,000 miles
Timing belt replacement: Every 105,000 miles
Transmission fluid: Every 30,000 miles (automatic)

WARNING! Always use genuine Acura parts and fluids for optimal performance and warranty compliance.

Engine System

Detailed procedures for engine maintenance, repair, and component replacement.

Engine removal and installation procedures
Cylinder head service and valve adjustment
Timing system inspection and belt replacement
Fuel system maintenance and injector service
Cooling system flush and thermostat replacement
Exhaust system inspection and component replacement

CAUTION! Always disconnect battery before performing electrical work on engine components.

Transmission System

Manual Transmission: Clutch replacement, gear oil change, shift linkage adjustment
Automatic Transmission: Fluid service, filter replacement, shift solenoid testing
Differential: Fluid replacement, seal inspection, bearing service
Drive Axles: CV joint service, boot replacement, axle removal
Transfer Case: Fluid service, seal replacement, component inspection

Brake System

Complete brake system service including disc brakes, ABS, and parking brake.

Front Brakes: Pad replacement, rotor resurfacing, caliper service. Rear Brakes: Shoe replacement, drum service, wheel cylinder inspection.

ABS System: Sensor testing, modulator service, bleeding procedures. Parking Brake: Cable adjustment, mechanism service, component replacement.

Suspension & Steering

Front and rear suspension components, steering system service, and alignment procedures.

Strut and shock absorber replacement
Control arm and bushing service
Stabilizer bar and link replacement
Power steering system service
Wheel alignment specifications and procedures
Wheel bearing replacement and service

Tip: Always perform wheel alignment after suspension component replacement.

Electrical System

Battery, charging system, starting system, and accessory electrical components.

Battery testing and replacement procedures
Alternator service and voltage regulator testing
Starter motor removal and component testing
Lighting system diagnosis and bulb replacement
Fuse and relay location guide
Wiring diagrams and connector information
ECU diagnosis and sensor testing procedures

WARNING! Always disconnect battery before performing electrical system repairs.

Body & Interior

Body panel replacement, interior component service, and trim procedures.

Diagnostic Procedures

OBD-II diagnostic procedures, trouble code definitions, and system testing.

CAUTION! Always follow proper diagnostic procedures to avoid unnecessary component replacement.

Technical Data

Torque specifications, fluid capacities, and technical reference data.

Engine Oil Capacity: 4.4 quarts with filter
Coolant Capacity: 6.9 quarts
Transmission Fluid: 2.2 quarts (manual), 7.4 quarts (automatic)
Brake Fluid: DOT 3 or DOT 4
Spark Plug Gap: 0.039-0.043 inches
Tire Pressure: 32 PSI (front and rear)

Troubleshooting Guide

Symptom	Possible Cause	Corrective Action
Engine won't start	Battery, starter, fuel system	Check battery voltage, test starter, verify fuel pressure.
Poor acceleration	Air filter, fuel filter, sensors	Replace air/fuel filters, test MAF and O2 sensors.
Brake vibration	Warped rotors, worn pads	Resurface or replace rotors, install new brake pads.
Steering pull	Alignment, tire pressure, suspension	Perform wheel alignment, check tire pressure, inspect suspension.
Electrical issues	Battery, alternator, grounds	Test charging system, check battery connections, inspect grounds.

Reset Procedures: ECU reset, maintenance minder reset, TPMS reset procedures.

Service Support: Contact Acura dealer or certified service center for technical assistance.