Oil Change Acura 2010 TSX Manual
The Acura 2010 TSX requires regular oil changes to maintain optimal engine performance and longevity. This manual provides comprehensive instructions for performing an oil change on your 2010 Acura TSX, including recommended oil types, filter specifications, step-by-step procedures, safety precautions, and maintenance schedules. Proper oil changes help ensure your vehicle runs smoothly and efficiently.
Recommended Oil and Filter Specifications
Using the correct oil and filter is essential for proper engine performance and protection.
| Component | Specification |
|---|
| Engine Oil Type | 5W-20 Synthetic Blend or Full Synthetic |
| Oil Capacity | 4.4 quarts (with filter change) |
| Oil Filter | Honda/Acura 15400-PLM-A02 or equivalent |
| Oil Viscosity | SAE 5W-20 |
| API Certification | SN or newer |
| Oil Drain Plug Torque | 29 lb-ft (39 N·m) |
| Oil Filter Torque | 7-9 lb-ft (10-12 N·m) |
Tools and Materials Required
Gather all necessary tools and materials before beginning the oil change procedure.
- 4.4 quarts of 5W-20 motor oil
- Oil filter (Honda/Acura 15400-PLM-A02)
- Oil drain pan (6+ quart capacity)
- Socket set (17mm socket for drain plug)
- Oil filter wrench
- Jack and jack stands or vehicle ramps
- Funnel
- Shop towels or rags
- Gloves and safety glasses
WARNING! Always use proper jack stands when lifting vehicle; never work under vehicle supported only by a jack.
Safety Precautions
Follow these safety measures to prevent injury and vehicle damage.
- Park on level surface and engage parking brake.
- Allow engine to cool for at least 30 minutes before starting.
- Wear safety glasses and gloves throughout the procedure.
- Use wheel chocks to prevent vehicle movement.
- Disconnect battery negative terminal for added safety.
CAUTION! Engine oil can be extremely hot; allow proper cooling time before beginning work.
Step-by-Step Oil Change Procedure
Follow these steps carefully for a successful oil change.
- Warm engine for 5-10 minutes to help oil flow more easily.
- Turn off engine and engage parking brake.
- Lift vehicle using jack and secure with jack stands.
- Place drain pan under oil drain plug.
- Remove drain plug with 17mm socket and allow oil to drain completely.
- Remove old oil filter using oil filter wrench.
- Apply thin coat of new oil to new filter's gasket.
- Install new filter by hand until gasket contacts base, then tighten 3/4 turn.
- Reinstall drain plug and torque to 29 lb-ft.
- Lower vehicle and add new oil through filler cap.
- Start engine and check for leaks.
- Check oil level and add if necessary.
Oil Reset Procedure
Reset the maintenance minder system after each oil change.
- Turn ignition to ON position (do not start engine).
- Press SELECT/RESET knob repeatedly until engine oil life appears.
- Press and hold SELECT/RESET knob for about 10 seconds.
- Oil life will blink and then reset to 100%.
- Turn ignition off and then start engine to verify reset.
Note: Failure to reset oil life may cause maintenance reminder to display incorrectly.
Maintenance Schedule
- Normal Driving Conditions: Every 7,500 miles or 12 months
- Severe Driving Conditions: Every 3,750 miles or 6 months
- First Oil Change: Within first 1,000 miles for new vehicles
- Oil Filter Replacement: Every oil change
- Drain Plug Washer: Replace every other oil change
Troubleshooting Common Issues
| Symptom | Possible Cause | Corrective Action |
|---|
| Oil leak after change | Loose drain plug or filter | Check and retorque drain plug and filter; replace crush washer |
| Low oil pressure light | Insufficient oil or wrong viscosity | Check oil level; verify correct oil type; inspect for leaks |
| Oil consumption | Worn engine components | Monitor oil level between changes; consult mechanic if excessive |
| Maintenance minder not resetting | Incorrect procedure | Repeat reset procedure; ensure ignition in ON position |
| Difficulty removing filter | Overtightened previous filter | Use proper filter wrench; apply penetrating oil if necessary |
Environmental Considerations
Proper disposal of used oil and filters is required by law and protects the environment.
- Collect used oil in sealed containers
- Take used oil to authorized recycling centers
- Drain oil filters for at least 12 hours before disposal
- Never dispose of oil in drains, soil, or trash
Important: One quart of used oil can contaminate 250,000 gallons of water.
Warranty Information
Performing your own oil change does not void Acura warranty as long as:
- Recommended oil specifications are followed
- Proper procedures are used
- Documentation of maintenance is kept
- Genuine Acura parts or equivalent are used
Keep receipts for oil and filters as proof of maintenance.
Technical Support
For additional assistance with your 2010 Acura TSX oil change:
- Acura Customer Service: 1-800-382-2238
- Acura Owner's Website: www.acuraowners.com
- Local Acura dealership service departments
- Certified Acura technicians
Always consult your owner's manual for specific vehicle requirements.
Oil Change Acura 2010 TSX Manual © - All Rights Reserved 2025